The T1 01.01.010 line kit is designed to be installed on the DSX Billet Intake Manifold with 20 port injectors, to be used in conjunction with the T1 01.01.03 In Tank Fuel System. Installation will be the same for both the second generation Audi R8 or Lamborghini Huracan. As is the case with any fuel system related work, all work should be performed by a qualified mechanic on a cool engine.
Filter securing tie with holes drilled:
Filter inlet check valve assembly:
The fuel filter outlet line to B1 Upper Rail can be seen below:
Although a little difficult to see fully with all components in place, you can see how the B1 Upper Rail to B1 DI Rail Line runs below:
In the images below you can actually see a few of the lines installed. You can see the B2 Upper Rail line running forward in parallel to the B2 DI Rail before looping to the left side of the car and going to the fuel pressure regulator. You can also see how the crossover line between the B1 and B2 DI Rails installs. Lastly, you can see the B1 Upper Rail to B2 Upper Rail crossover line at the firewall:
Another angle showing the two lines that run off the B2 Upper Rail:
Although a bit hard to photograph in car, you can see the previously mentioned line from the B2 Upper Rail along with return line off the B2 DI Rail routed along the firewall going to the fuel pressure regulator. The B2 DI Rail line terminates on the left side of the regulator with a 180° fitting through the ethanol content sensor, while the B2 Upper Rail line terminates on the right side of the regulator:
In addition to both of the B2 lines covered in the previous set of images, you can the return line off the bottom of the fuel pressure regulator which terminates at the OE hard feed line in the image below:
