The GT1R CFS (Complete Fuel Solution) Gauge kit is an all inclusive fueling solution capable of supporting over 1,400whp on ethanol fuel (limited by 6 injectors). This kit sets fuel pressure with a mechanical gauge near the fuel pressure regulator. This kit does not allow ECU monitoring/logging of fuel pressure and is not recommended if the system is capable of monitoring fuel pressure. There are many advantages to datalogging fuel pressure, as well as safety parameters that can be setup to shut things down in the event of low fuel pressure. This package does not include the Fore triple pump hanger, lines connecting the hanger to the factory feed/return lines, or the FC3 controller.
Starting from the factory feed line this kit uses Redhorse Performance products throughout, all hose being ethanol compatible and all hose ends being Redhorse 7000 series swivel and crimp style. The quick disconnect adaptors we use for the hard line adaptors are the thread on type, not the clip on type, so they can not pop off, like the clip on style is subject to. A 6AN hose runs to the front of the engine, where the ID F750 fuel filter is mounted. The filter location allows easy visibility of the DeltaP indicator on the front, which tells you when it's time to change the filter element, and also allows for quick and easy replacement of the element, with no tools required.
From the filter outlet there's a 6AN line that runs up to the Flex Fuel sensor, mounted to the intake manifold crossover tube (works with stock, Boost Logic, or Greddy intake manifolds), again using the thread on style quick disconnect adaptors for safety and reliability.
Out of the Flex Fuel Sensor we go to the bank 1 GT1R fuel rail inlet, and from the bank 2 fuel rail outlet, we go to the Fore Innovations F2i fuel pressure regulator, mounted on the firewall, reusing the OE rubber isolators from the factory fuel line bracket. The mechanical fuel pressure gauge is located on the inlet of the FPR. From the regulator return we go back to the OE return line.
All engine bay lines include a high temp heat sleeve to minimize fuel temperature induced by radiated heat in the engine bay.
There's not a cleaner and easier to install system than this for the R35.
